Static NAT

Static NAT
www.netprotocolxpert.in

 With static NAT, routers or firewalls translate one private IP
address to one public IP address.
 Each private IP address has been mapped to a single public IP
address. Static NAT is not often used because it requires one
public IP address for each private IP address.
 To configure static NAT, three steps are required:
1. Configure private/public IP address mapping by using the ip nat
inside source static PRIVATE_IP PUBLIC_IP command
2. Configure the router's inside interface using the ip nat
inside command
3. Configure the router's outside interface using the ip nat
outside command

 Computer A requests a web resource from S1.
 Computer A uses its private IP address when sending the request
to router R1.
 Router R1 receives the request, changes the private IP address to
the public one and sends the request to S1.
 S1 responds to R1. R1 receives the response, looks up in its
NAT table and changes the destination IP address to the private IP
address of Computer A.

 In the example above, we need to configure static NAT. To do that,
the following commands are required on R1:

 Using the commands above, we have configured a static mapping
between Computer A's private IP address of 10.0.0.2 and router's
R1 public IP address of 59.50.50.1. To check NAT, you can use the
show ip nat translations command:

Static NAT

Recommended

Recommended

More Related Content

What's hot

What's hot (20)

Viewers also liked

Viewers also liked (8)

Similar to Static NAT

Similar to Static NAT (20)

More from NetProtocol Xpert

More from NetProtocol Xpert (20)

Recently uploaded

Recently uploaded (20)

Static NAT