Portal and cantilever method

Approximate Methods for Analysis of Indeterminate Structures
(Ref: Chapter 7)
Approximate analysis is useful in determining (approximately) the forces and moments in the
different members and in coming up with preliminary designs.
Based on the preliminary design, a more detailed analysis can be conducted and then the design can
be refined.
Approximate analysis is conducted by making realistic assumptions about the behavior of the
structure.
Approximate Analysis of Indeterminate Trusses
During preliminary design and analysis, the actual member dimensions are not usually known.
(because they are designed to be long and slender)
In this case, the truss is usually determinate because only
one of the diagonals is active. The "compression"
diagonal behaves as a zero-force member.
Case 1: Diagonals CANNOT carry compression
In this case, both diagonals will be assumed to carry half
the panel shear.
Case 2: Diagonals CAN carry compression
Find the forces in the truss members
If diagonals cannot carry compression•
If diagonals can carry compression•
Example
ApproximateMethods Page 1

Portal Frames and Trusses
Case 1: Pin supported
Case 2: Fixed Supported

Case 3: Partial Fixity
Case 4: Portal Trusses
Example
Find the forces in the members of the truss

Frame Structures with Vertical Loads
Assume hinge at 0.1 L
Find the moments (in the beam) at joints E and C
Example

Frame Structures with Lateral Loads: Portal Method
the frame can be viewed as a superposition of a number of portals.
For low-rise building frames under lateral loads,
Internal hinges at the centers of beams and columns•
Shear carried by interior columns is assumed to be
twice of that of the exterior columns.
•
Assumptions:

Find the reactions at the base of the columns
using the portal method of analysis.
Example
In a similar way, proceed from the top to bottom, analyzing each of the small pieces.
Level 2
Level 1

Frame Structures with Lateral Loads: Cantilever Method
the entire frame acts similar to cantilever beam sticking out of the ground.
For tall and slender building frames under lateral loads,
created due to the lateral load around the base of the building.
Axial compression and tension forces develop to counteract the moment
Internal hinges form at the center of beams and columns•
Axial stress in a column is proportional to its distance away from the
centroid of the cross-sectional area of columns.
•
Assumptions:

Find the reactions at the base of the columns
using the cantilever method of analysis.
Example
Note the areas of cross-sections of the columns
are different.
Once κ (the constant of proportionality) is obtained, one can obtain the column forces FL, FM, FN, and FO.
Then the rest of the analysis would proceed in a similar way to the Portal method, analyzing each of the
small pieces between the assumed hinges from top to bottom.

Using the cantilever method, find the reactions
at the base of the frame.
All columns have the same cross-sectional area.
Example
Once again, each of the small pieces
will have only 3 unknowns and can
be solved for using Statics.

In a similar way, proceed from the top to bottom, analyzing each of the small pieces.

Portal and cantilever method

Recommended

Recommended

More Related Content

What's hot

What's hot (20)

Similar to Portal and cantilever method

Similar to Portal and cantilever method (20)

More from Prionath Roy

More from Prionath Roy (20)

Portal and cantilever method